基于CFD软件的并条机吸风系统优化设计
2022-04-15 11:28:13   来源：   评论：0 点击：

  关键词：并条机；吸风系统；风道优化；吸风口；负压；风道；CFD软件；仿真
中图分类号：TS112.2          文献标志码：B          文章编号：1001-9634(2022)01-0023-04
 
收稿日期：2021-04-24
作者简介：郑升圆（1983—），男，辽宁凤城人，工程师，主要从事机械设计制造及自动化方面的工作。
   
Abstract:In order to optimize the suction system structure for drawing frame and ensure the balance of suction force of each suction outlet in clean housing，the working principle and existing problems of suction system for drawing frame are introduced，and the specific adjustment methods and limitations are analyzed.CFD simulation analysis tool SolidWorks Floworks is used to simulate and design the air duct of suction system for drawing frame，and the simulation optimization results are compared with the actual test data.It is pointed out that after optimizing the suction system for drawing frame with CFD software，the air duct structure increases the turning transition section of the air duct，and the connection area between the air duct and the rear wall panel increases，the vortex disappears，and the flow is more smooth and uniform.By comparied the negative pressure and wind speed，the average negative pressure increases，and the flow rate also increases slightly.Using Floworks simulation software of CFD can provide optimization direction for air duct design，improve design speed，reduce development cost and shorten development cycle.
Key Words:drawing frame；suction system；air duct optimization；suction inlet；negative pressure；air duct；CFD software；simulation
 
参考文献：
[1] 潘雷，苏树为.有进出口的容器内流体流动数值分析[C]//山东省暖通空调制冷2007年学术年会论文集，2007：619-622.
[2] 谢永奇,高红霞，余建祖，等.JWF-A型并条机吸风系统气流流场的数值仿真[J].纺织学报，2009，30（9）：109-114.
[3] 张晓英，张美红，张震，等.CFD技术在喷水推进泵级内部流动计算中的应用[J].车辆与动力技术，2004，96（4）：41-44.
[4] 王维滨.FA302型并条机吸风系统的使用实践[J].棉纺织技术，1995，23（5）：37-38.
[5] 张文赓.纺织气流问题[M].北京：纺织工业出版社，1989.
[6] 王介生.棉纺工程中气流的应用与分析[J].棉纺织技术，2000，28（10）：56-59.
[7] 贾成举.基于Floworks软件的并条机风道优化分析[J].纺织器材，2015，42（4）：43-45.